Hello Community, I have a curious question. Is there a way to snapshot set p on set b without the need to upgrade the vmhost again? ------------------------------ KRITIKA SUNNOO ------------------------------

Hello, I'm trying to configure VLAN-rewrite on ex3400-48t( Junos: 21.4R3-S6.5 ) on port configured as RTG group ,the issue that VLAN-rewrite doesn't work until I remove RTG group on both interfaces . found bellow the configuration ; set interfaces ge-0/0/6 speed 1g set interfaces ge-0/0/6 link-mode ...

sir, if I use master password, it will hash it as $9. when I pull a config file with hashed key $9, the srx errors out. if I replace the hashed key with $8, the newly loaded config file has no issue. is there a way to force the SRX to generate $8 hashed key so I can transit the config file from one ...

This message was posted by a user wishing to remain anonymous Hi, I am facing an issue with Juniper SRX 1600 for SFP and SFP + port. SFP ports are not showing in cli while entering the command show interface terse. PIC 1 and PIC 2 are showing as online but the ports are not listing. And also ...

Is this method supposed to help in capturing mpls packets ? I aim to capture traffic that contains L2VPN & L3VPN labeled packets like this : https://packetlife.net/media/captures/EoMPLS_802.1q.pcap.cap https://packetlife.net/media/captures/EoMPLS.cap Thanks in advance for your kind help. ...

hello, I am new to the community and to Junos family, I need help with (ex4200-24/48) & (ex2200-24-4g). I am trying to set IP address to multiple Junos switches without losing any current configuration. right now, the switches are set to the correct Vlan but the IP's need to be in range. any help ...

This message was posted by a user wishing to remain anonymous Folks, Can someone shed light on something basic? I thought Anycast SID in SR-MPLS is ECMP aware. I do get two routes out of two different interfaces, but observe no ECMP behavior and the traffic (1000 ICMPs x 5 separate tries) leaves ...